Deckma Hamburg OMD-2008 Instruction Manual page 2

DECKMA HAMBURG GmbH
IMPORTANT NOTICE
Replacement components for 15ppm Bilge Alarms.
General
All monitors in our range are inspected and tested to the related I.M.O.
requirements at our factories prior to delivery. In normal use the units should
operate correctly and without fault over a long period of time requiring only small
amounts of maintenance to be carried out as outlined in the instruction manuals.
It is very important to correctly identify the Type and Version of the instrument for
technical support, or for ordering spare parts. Please include instrument type,
Version, and serial number, and if possible instrument date of commissioning into
any communication.
Service Exchange Units
In the event of a monitor malfunction due to electrical or electronic component
failure it is our recommendation that a service exchange unit be ordered.
The defective instrument should be returned to our works within 30 days of
supplying the service exchange unit, then only the repair charge is payable.
Otherwise the whole cost of a service exchange unit becomes payable.
This procedure is by far the easiest and most cost effective way of ensuring the
monitor on board conforms to I.M.O. resolution MEPC.107(49).
Remark:
According the MEPC.107(49) § 4.2.11 the unit has to be checked at IOPP
Certificate renewal survey by the manufacturer or persons authorized by the
manufacturer. Alternatively the unit may be replaced by a calibrated 15 ppm Bilge
Alarm.
The OMD-2008 EVFC is designed in that way, that only the measuring cell needs
to be changed, as this unit carries the Calibration Certificate. The Calibration
Certificate with the date of the last calibration check should be retained onboard
for inspection purposes.
If for some reasons the computer unit needs to be changed, it has to be made
sure, that the Memory Card will remain on board for at least 18 month. The new
computer unit will carry its own memory card. The old card can be insert into the
new unit only for reading. Writing is only possible with the card delivered with the
new computer unit. For details see section 13.1.
Issue: 25.09.2015 preliminaryInstruction Manual OMD-2008 (All Versions) Page 1 of 28