5
Commands by Subsystem
:TIMebase:POSition
Command Syntax
:TIMebase:POSition <pos>
<pos> ::= time in seconds from the trigger to the display reference
The :TIMebase:POSition command sets the time interval between the
trigger event and the display reference point on the screen. The display
reference point is either left, right, or center and is set with the
:TIMebase:REFerence command. The maximum position value depends on
the time/division settings.
This command is an alias for the :TIMebase:DELay command.
N O T E
Query Syntax
:TIMebase:POSition?
The :TIMebase:POSition? query returns the current time from the trigger to
the display reference in seconds.
Return Format
<pos><NL>
<pos> ::= time in seconds from the trigger to the display reference
See Also
•
•
•
•
•
•
458
(see
page
786)
in NR3 format
in NR3 format
"Introduction to :TIMebase Commands"
":TIMebase:REFerence"
":TIMebase:RANGe"
on page 459
":TIMebase:SCALe"
on page 462
":TIMebase:WINDow:POSition"
":TIMebase:DELay"
on page 737
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 456
on page 461
on page 464