Trigger:eburst:idle - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:TRIGger:EBURst:IDLE

Command Syntax
:TRIGger:EBURst:IDLE <time_value>
<time_value> ::= time in seconds in NR3 format
The :TRIGger:EBURst:IDLE command sets the Nth edge in a burst idle
resource in seconds from 10 ns to 10 s. The timer is used to set the
minimum time before the next burst.
Query Syntax
:TRIGger:EBURst:IDLE?
The :TRIGger:EBURst:IDLE? query returns current Nth edge in a burst idle
setting.
Return Format
<time value><NL>
<time_value> ::= time in seconds in NR3 format
See Also
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:EBURst:SLOPe"
":TRIGger:EBURst:COUNt"
on page 467
on page 498
on page 496
Commands by Subsystem
5
497