Jøtul I 570 Manual page 71

Fig. 3 C
3. The further facilitate installation, remove burner plates (fi g.
3B-G/F), vault (fi g. 3C-A), baffl e plate (fi g. 3C-B), cube
stopper (fi g. 3B-C), inner bottom (fi g. 3B-D) and ashtray
(fi g. 3B-E). See section "4.1 Replacement of burner
plates / vault / baffl e."
Attaching legs and screen plate to the
fl oor
Fig. 4
4. Remove the insert shield plate by unscrewing the upper
screw on both sides of the insert (fi g. 4 A). Lossen the lower
screws (fi g. 4 B) and pull up the screen plate and lift off .
5. Carefully place the insert on the back (use the wooden
pallet and cardboard packaging on the fl oor to protect it).
Fig. 5
6. Assemble the 4 legs (fi g. 5 A) with the 4 joints (fi g. 5 C) with
4 pcs. screws and nuts located in a bag in the box.
Fig. 6
7. Then mount these on the insert using 3 screws M8 x 25
mm collar head (fi g. 6 B). The screws are attached to the
insert bottom from before. Adjust the joints so that the
desired height is achieved.
8. Raise the combustion chamber.
9. Fine adjustment of the legs is only done when the insert
has been tested.
Fig. 7
10. The washer (fi g. 7 A) should be placed under the screw
heads, both to protect the surface, and to prevent the insert
from shifting. Fine adjustment is made using M10 x 45 mm
screws (fi g. 7 B) which are attached to the joints.
ENGLISH
71