Pepperl+Fuchs MLV11 Series Manual

MLV11 Series - Introduction
Parameter settings
Through-beam type (M11/MV11...),
reflextype (MLV11-54...),
diffuse type (MLV11-8), light guide
connection type (MLV11-LL)
Parameter:
- Outputs:
- Pre-fault signal:
- Switch freq. → Switch delay:
- Hysteresis:
- Time function 1:
- Time function 2:
- Pulse frequency:
- Keypad settings:
- Input functions:
- Input inverted:
- Parameterisation disable:
Subject to reasonable modifications due to technical advances.
1
Pepperl+Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com
Parameterisation via optical interface (PC or handheld).
Default settings underlined
• N.O. and pre-fault
• N.C. and pre-fault
• Antivalent
• dynamic
• static
• OFF
→
• 1 kHz 0.5 ms
→
• 500 Hz 1 ms
→
• 250 Hz 2 ms
→
• 100 Hz 5 ms
→
• 50 Hz 10 ms
→
• 20 Hz 25 ms
for application-optimised interference suppression
• small
• standard
• large
• none
• ON delay (0.1 s to 25.5 s in 0.1 s steps)
• none
• OFF delay (0.1 s to 25.5 s in 0.1 s steps)
• Pulse extension (1 ms to 255 ms in 1 ms steps)
• One shot output function (1 ms to 255 ms in 1 ms steps)
• Pulse frequency 1
• Pulse frequency 2
• Pulse frequency 3
• OFF
• automatic
• always
• none
• Test (emitter deactivation)
• AND-Logic-Operation
• OR-Logic-Operation
• XOR-Logic-Operation
• NC/NO switching
• Function reserve test (normal operation with half transmission power) only for
MLV11... sensors.
• TEACH-IN (level controlled) only for MLV11... sensors
• LATCH only for MLV11... sensors.
• D-Flipflop only for MLV11... sensors
• all control input functions can be inverted
• OFF
• ON
Copyright Pepperl+Fuchs, Printed in Germany