Sc5511A_Store_Default_State; Sc5511A_Rf2_Standby; Sc5511A_Synth_Self_Cal - SIGNALCORE SC5511A Operating & Programming Manual

Function:

sc5511a_store_default_state

Definition: int sc5511a_store_default_state(sc5511a_device_handle_t
Input: sc5511a_device_handle_t
Description: sc5511a_store_default_state stores the current configuration into EEPROM memory as
the default state upon reset or power-up.
Function: sc5511a_set_rf2_standby
Definition: int sc5511a_set_rf2_standby(sc5511a_device_handle_t
Input: sc5511a_device_handle_t
unsigned char
Description: sc5511a_set_rf2_standby powers down channel RF2.
Function: sc5511a_set_rf2_freq
Definition: int sc5511a_set_rf2_freq(sc5511a_device_handle_t
Input: sc5511a_device_handle_t
unsigned short
Description: sc5511a_set_rf2_freq sets the frequency for channel RF2.
Function:

sc5511a_synth_self_cal

Definition: int sc5511a_synth_self_cal(sc5511a_device_handle_t
Input: sc5511a_device_handle_t
Description: sc5511a_synth_self_cal will cause the device to perform a self calibration of the DAC
values to properly set the VCO up for phase lock. When the device uses the harmonic -
generator as the offset loop, the VCO could potentially lock to a wrong reference
harmonic causing the sum PLL to fail. Perform this function if the sum PLL fails when the
synthesizer is in harmonic lock mode. Allow 2-3 seconds for the calibration routing to
execute, and upon completion the device will reset. The status indicator of RF1 will go
off, then red, then amber, and then finally green.
SC5511A User Manual
*dev_handle
*dev_handle
enable
*dev_handle
freq
*dev_handle
Rev 1.7.0
*dev_handle)
(handle to the opened device)
*dev_handle,
unsigned char
(handle to the opened device)
(enable the device to go in standby mode)
*dev_handle,
(handle to the opened device)
*dev_handle)
(handle to the opened device)
enable)
unsigned short freq)
(frequency in MHz)
36