Maintenance; Periodic Inspection Table - CanyCom S100 Operator's Manual

7

7. Maintenance

7.1 Periodic Inspection Table

Failure to carry out inspection and maintenance properly will cause machine failure.
Refer to the following table for inspection procedures and frequency.
Some inspection and maintenance procedures in the table below require tech-
nical knowledge or specific tools and measuring instruments. If you have
difficulty performing these procedures, or do not have the correct tools or
instruments, contact your dealer or a Canycom service center.
Item
Ease of
starting
Condition
of rotation
Exhaust
gas
condition
Air
cleaner
Tightening
Valve
clearance
Maintenance
Content of inspection
• Investigate starting condition
of engine check for abnormal
noise.
• Check if glow plug works prop-
erly.
• Check speed at low idling at
high idling.
• Check that rotation is smooth.
• Check for catching of accel-
erator lever when accelerating
engine, stall, or knocking.
• Warm up engine thoroughly,
then check for abnormal
exhaust gas color or exhaust
sound, low idling to high idling.
• Check for gas leakage from
exhaust pipe or muffler.
• Check for cracks, deformation of
case, looseness of cover or con-
necting piping.
• Check for dirty or damaged ele-
ment.
• Check for looseness of nuts and
bolts at tightening portion of cyl-
inder head and manifold.
* If no leakage of gas or water is
found from these portions, this
check can be omitted.
• Check the valve clearance
* When noise due to abnormal
valve clearance is absent and
the engine is running smoothly,
this inspection may be omitted.
Check that engine starts
smoothly and makes no
abnormal noises.
Must work properly.
Must be at specified
speed.
Must rotate smoothly.
There must be no
catching, stalling of
engine, or knocking.
Exhaust gas color and
exhaust sound must be
normal.
There must be no gas
leakage.
There must be no
cracks, deformation of
case, looseness of cover
or connecting piping.
There must be no
noticeable dirt or dam-
age.
If gas or water leaks
have found, check cylin-
der head and manifold
retaining nuts and bolts
for looseness.
The valve clearance
must be normal.
- 28 -
Inspection
interval
Remarks
○ ○ ○
○ ○ ○
Please contact your
○ ○
Canycom distributor
for inspection.
○ ○ ○
○ ○ ○
○ ○
○ ○
Cleaning /
○ ○
replacement:
See page 41
○
Please contact your
Canycom distributor
○
for inspection.