Song Job Mode; Copying Measures Between A And B; Deleting Measures Between A And B - Yamaha GW50 Owner's Manual

SONG MODE
BACKING SECTION
5.
Press
Recording will start from the point selected,
continue to measure B, go back to measure
A, and repeat between A and B indefinitely.

SONG JOB MODE

This function allows you to copy the data between
the two marked measures to another location in the
song. This is a convenient composing tool, since it
lets you easily copy parts of the song that are
similar (such as the verse sections), without having
to program each measure.
1.
Mark the A and B points of the measures you
wish to copy.
2.
Use the position controls to select the desti-
nation measure.
3.
Simultaneously hold down
tion controls to select the destination measure
here, if you wish.)
4.
Press (below "GO") to copy the
measures, or press
to abort the operation.
Note:
In the Copy and Delete operations, the
measure numbers for the A and B points do not
change after the operations, but the actual
contents may be altered. For this reason, you
should be careful when copying the same
section to different parts of the song, for exam-
ple; the desired section may have been moved
from its original location because of a Copy or
Delete operation.
94
SONG JOB MODE
to begin recording.
and press
. (You can still use the posi-
(below "EXIT")
6.
Press
7.
To turn off the repeat function, simultane-
ously hold down
again.
Before copying
Original measures 17 and beyond are moved forward
the end of the song to make room for the copied measures.
Notice that this operation inserts the measures at
the destination and shifts all existing measures
there forward toward the end of the song to make
room for the copied measures.
This function allows you to delete a specified
range of measures from a song.
1.
Mark the A and B points of the measures you
wish to delete.
2.
Simultaneously hold down
.
3.
Press (below "GO") to delete the
selected measures, or press
"EXIT") to abort the operation.
to stop recording.
and press
and press
(below