Yamaha GW50 Owner's Manual page 30

Note:
To set the controls on the GW50 to minimum,
turn them all the way counterclockwise.
7.
Turn on the power of all the equipment,
starting with the GW50, then the connected
amplifier.
* Adjust the LCD SETTING switch on the
rear panel to set the LCD for proper view-
ing. Set it to FLOOR when you are using
the GW50 on the floor, and to DESKTOP
when you have it set on a table or desk in
front of you.
8.
Before turning up the volume and trying to
play, set all effects to off.
To do this, press
LED is lit) ...
...then, if any effect block LED is lit, press
Pedal Switches 1–5 to turn all effects off (all
effect block LEDs should be off).
(even if the
off
press these
9.
While playing your guitar, slowly bring up
the volume controls to suitable levels —
starting with the amp, then the guitar output.
Finally, adjust the input level control on
the rear panel. Increase the level slowly as
you play the guitar while looking at the
INPUT PEAK indicator on the panel. The
indicator should flash only slightly when you
play the guitar at its loudest.
Also, check that the guitar sound doesn't
have distortion at its loudest.
10.
Do the same with the BACKING LEVEL.
First turn the backing on by pressing
...then turn up the BACKING LEVEL to a
suitable volume.
If you've followed all these instructions carefully,
you should be able to hear both your guitar sound
processed by the effects, and the sound of the
backing parts.
Note:
To stop the backing, press [START/STOP]
again.
SETTING UP AND PLAYING YOUR GW50
GUIDED TOUR (TUTORIAL)
...
21