Yamaha GW50 Owner's Manual page 34

3.
Now, try a heavy distortion sound. Use the
[–]/[+] buttons again, this time selecting
program number 74.
4.
Next, let's call up a classic rock'n'roll delay
effect. This time though, use the Pedal
Switches to select the program. (If the
MEMORY LED in the ASSIGNABLE Block
is flashing, press the ASSIGNABLE Block
Pedal Switch to make it light continuously.)
Press Pedal Switch 1. This selects program
number 71.
Notice that the program numbers all have two
digits. The first number is actually the bank
number. The 50 programs are divided into 10
banks of five programs each. In the last step,
you just selected the 1st program of the 7th
bank.
5.
To select both a bank number and program
number with the Pedal Switches, press the
ASSIGNABLE Block Pedal Switch once.
The bank number flashes
to indicate the bank can be selected.
s
6.
Press the Pedal Switch corresponding to the
bank you wish to select, 1 – 5 (printed at the
top left of each Pedal Switch).
s
To select one of the banks 6 – 0, simultane-
ously press and hold down the ASSIGN-
ABLE Block Pedal Switch, and press the
corresponding Pedal Switch, 6 – 0 (printed at
the bottom left of each Pedal Switch).
7.
Finally, select one of the five programs in the
bank (as you did in step #4 above).
8.
Now, go on to explore some of the other
effect programs, selecting them either with
the [–]/[+] buttons or the Pedal Switches.
Look through the Preset Effect Program list
on page 132 for more information about the
programs, and play with a few of them to
hear how they sound.
GUIDED TOUR (TUTORIAL)
s
25
EFFECT SECTION