Min Vol - Yamaha GW50 Owner's Manual

You can set the minimum volume of the
foot controller to a value other than zero
(for example, when you want to use the
HINT
foot controller to easily move between loud
and soft settings). See "Setting the
MINIMUM VOLUME Level" on page 47 for
details.
— For using the foot controller to
control the Wah effect or filter sweep, when the
Wah + EQ effect is selected in the Equalizer
block. (When the external foot controller is set
to Wah Pedal operation here, the Wah + EQ
Type parameter is automatically set to
PEDAL.) Refer to page 61 for more informa-
tion on the Wah + EQ effect.
the foot pedal to control the Distortion Drive
parameter (see page 59).
foot controller to control the Depth parameter
of the Chorus, Flanger or Phaser effects, or the
Mix parameter of the Pitch Shift effect (see
pages 64-66).
foot controller to control the High parameter of
the Reverb effect, the Feedback parameter of
the Delay effect, or the Delay Mix parameter of
the Delay + Reverb effect (See pages 67-69).
controller to control the Reverb Mix parameter
of the Reverb effect, the Delay Mix parameter
of the Delay effect, or the Reverb Mix param-
eter of the Delay + Reverb effect (See pages 67,
68).
Note:
When selecting Wah Pedal and control of other
parameters for the foot controller, make sure
that the foot controller is properly connected to
the GW50.
— For using
— For using the
— For using the
— For using the foot
EFFECT SECTION
Note:
When using the foot controller as a Wah pedal or to
control one of these other parameters, the ASSIGN-
ABLE Block functions MIN/MAX VOLUME and AUTO
VOLUME apply only to the volume of the first three
effects (Compressor, Distortion and Equalizer).
ASSIGNABLE block's MIN/MAX
VOLUME and AUTO VOLUME
control placed here.
When using the connected foot controller as a
volume pedal (see previous page), you can set the
minimum volume for the controller from the
GW50.
When using the ASSIGNABLE Block Pedal
Switch to control MIN/MAX Volume or Auto
Volume (see pages 48, 49), this parameter also
determines what the minimum volume will be for
both of these functions.
1.
From the Manual mode, repeatedly press the
Utility button until "MIN" is shown in the
display.
2.
Use the / buttons to set the desired
Minimum Volume value. (Range: 0–9)
A minimum setting of "0" results in no
output or off, while a maximum of "9" re-
sults in the same level as normal (or no
volume change).
Note:
Keep in mind that a maximum setting of "9" results in
no volume change for ALL related functions — the foot
controller, and the ASSIGNABLE Block Pedal Switch's
MIN/MAX Volume and Auto Volume functions.
MANUAL MODE
47
MANUAL MODE