Iinstallation; I1 Positioning, Configurations And Accessories - Graco 127643 Instructions Manual

I INSTALLATION
EN
WARNING
WARNING
NOTICE
PRELIMINARY - Verify that all components are present. Request any missing parts
INSPECTION
- Check that the pump has not suffered any damage during trans-
- Carefully clean the suction and delivery inlets and outlets, remov-
- Check that the electrical data corresponds to those indicated on
- Always install in an illuminated area.
- Install the pump at a height of min. 80 cm (31.5 in).
I1 POSITIONING, CONFIGURATIONS AND ACCESSORIES
NOTICE
NOTE
NOTICE
NOTICE
8
FIRE AND EXPLOSION HAZARD
The motors are not of the anti-explosive-type.
do not install them where infl mmable vapours could
be present.
EQUIPMENT MISUSE HAZARD
It is the responsibility of the installer to provide the
necessary line accessories to ensure the correct
and safe operation of the pump. The accessories
that are not suitable to be used with the previously
indicated material could damage the pump and/
or cause injury to persons, as well as causing
pollution.
The pump must never be operated before the deliv-
ery and suction lines have been connected.
from the manufacturer.
port or storage.
ing any dust or other packaging material that may be present.
the data plate.
In the case of installation in the open air, proceed to
protect the pump by providing a protection roof.
The pump can be installed in any position (pump axis
vertical or horizontal)
The pump must be secured in a stable way using the
holes on the bed of the motor and vibration damping
devices.
The broad range of pump accessories make it suit-
able for many different uses, installations and ap-
plications. The supporting base can be positioned in
different ways.
To maximise performance and prevent damage
that could affect pump operation, always de-
mand original accessories.
M0309