ENG
How To Exit For SERVICEMAN
If you have set all the parameter.
Press ''BACK'', the following page will appear:
Select ''YES'' and press ''OK'' to exit the FOR
SERVICEMAN.
After exiting the FOR SERVICEMAN, the unit
will be Turned OFF.
Network Configuration Guidelines
The wired controller realizes intelligent
control with a built‐in module, which receives
control signal from the APP.
Before connecting the WLAN, please check
for it if the router in your environment is
active and make sure that the wired
controller is well‐connected to the wireless
signal.
During the Wireless distribution process, the
LCD icon "
"
flashes to indicate that the network is being
deployed. After the process is completed, the
icon "
" will be constantly on.
Wired Controller Setting
The wired controller settings include AP
MODE and RESTORE WLAN SETTING.
29
-
Activate the WLAN by interface.
Go to "MENU"> "WLAN SETTING"> "AP
MODE".
Press "OK", the following page will appear:
Use ''◄'',''►'' to move to "YES", press
"OK" to select AP mode.
Select AP Mode correspondingly on the
mobile device and continue the follow‐up
settings according to the APP prompts.
CAUTION
After enter Ap mode, if it's not connected
with mobile phone, the LCD icon "
flash 10 minutes then disappear.
If it's connected with the mobile phone, the
icon "
" will be constantly display.
Restore WLAN setting by interface.
Go to "MENU"> "WLAN SETTING" >
"RESTORE WLAN SETTING" .
Press "OK", the following page will appear:
Use ''◄'' ''►'' to move to "YES", press "OK"
to restore WLAN setting.
Complete the above operation and wireless
configuration is reset.
VIVAX
" will