Vari Ef Dry:wet - Yamaha AN1x Owner's Manual

Data
The Data parameter lets you select the Variation Effect
type and change data values of the selected effect or
EQ Parameter.
Settings:
For information about each Parameter and available settings,
see the Effect Type List in the separate Data List book.
Setting the Variation Effect
1. Press the lower area of the Param [UP/DOWN]
switch to select Variation Effect.
2. Press Data [UP/DOWN] to select the type of
Variation Effect. (There are 14 types; see the
Data List book.)
3. Press Param [UP/DOWN] again to select the
specific parameter that you want to set. (The
parameters for the Variation Effect which you
selected in step 2 will be available.)
4. Press Data [UP/DOWN] again to set the
Parameter value.
5. Repeat steps 3 and 4, above, to set data values
for other parameters of the selected Variation
Effect.
For more information about the Variation Effect, see the separate Data List book.
Setting the Equalizer
1. Press Param [UP/DOWN] to select an EQ
parameter. (There are seven EQ parameters; see
the separate Data List book.)
2. Press Data [UP/DOWN] to set the value of the
selected parameter as desired.
3. Repeat steps 1 and 2, above, as many times as
necessary to select other parameters and set
their data values.
For more information about the EQ parameters, see the separate Data List book.

Vari EF Dry:Wet

The Variation Effect Dry:Wet setting determines the
balance between wet (effect) and dry (original) signal
levels. A setting of "D63" will pass the dry signal only,
and a setting of "W63" will pass the wet signal only.
A setting of "D=W" represents an equal balance of
wet and dry signals.
Settings: D63 ~ D=W ~ W63
When Vari EF Param type is set to "AuralExc" or "Comprssr", Data "dry" and
"wet" settings are available. When Vari EF Param type is set to "OvrDrive" or
"Amp Sim", Data "dry", "both" and "wet" settings are available.
Aural Exciter is a registered trademark of and is manufactured under license from
Aphex Systems Ltd.
78