Sync/Fm - Yamaha AN1x Owner's Manual

s/h (Sample & Hold) Wave
s/h
s/h
s/h2
s/h2
Compared with "s/h", s/h2 is biased to the positive range.
LFO1 Spd
(LFO1 Speed)
The LFO1 Speed setting determines the rate of LFO1.
Turning the knob to the left results in slower rates and
turning it to the right results in faster rates. (For details
about the LFO Reset function, see page 73.)
Slow Speed
Settings: 1 ~ 256
Fast Speed
58
LFO1 Dly
(LFO1 Delay)
The LFO1 Delay setting determines the delay time of
the modulation. Turning the knob to the left results in
shorter LFO1 Delay times, and turning it to the right
results in longer Delay times.
Short Delay
Settings: 0 ~ 127
LFO2 Spd
(LFO2 Speed)
Description, parameters and values for LFO2 Speed
are the same as for LFO1 Speed, above.
The LFO2 wave is fixed to "triangle", and cannot be changed.

SYNC/FM

When KNOB PARAMETER GROUP switch [SYNC/FM] is
selected, the eight CONTROL knobs will access specific
Sync function- and Frequency Modulation-related
parameters.
Sync parameters are related to the synchronization status
of the two VCO1 oscillators (master and slave), which are
the fundamental waveform generating elements in the
AN1x.
A Frequency Modulation (FM) signal ("modulator") can be
applied to the VCO1 in one of several ways to change its
frequency, in which case the output of the oscillator will
become the modulated signal ("carrier").
For more information about Sync and FM, pages 31, 59.
Long Delay