Yamaha AN1x Owner's Manual page 79

Dly/Rev EF
(Delay/Reverb Effect)
Delay/Reverb Effect settings determine the Delay and
Reverb effect types and data settings. There are two
parameters available, Param (Parameter) and Data.
The Delay and Reverb effects are located after the EQ output, and can be
connected in series or parallel. For more information, see the separate Data List
book.
Param
(Parameter)
The Parameter setting lets you select the Connect,
Delay effect (and parameters) and Reverb effect (and
parameters).
Data
The Data parameter lets you select the Connect
settings, Delay type (and change data values for Delay
parameters) and Reverb type (and change data values
for Reverb parameters).
Settings:
For information about available parameters and value settings
for Delay and Reverb effects, see the separate Data List book.
Setting Delay and Reverb
1. Press the lower area of the Param [UP/DOWN]
switch to select the Connect parameter.
2. Press Data [UP/DOWN] to select serial ("seri")
or parallel ("para") and set the configuration of
the Delay and Reverb effects.
3. Press Param [UP/DOWN] again to select either
the Delay ("DlyEF") or Reverb ("RevEF") page.
When Delay is
selected, "DlyEF"
appears here
4. Press Data [UP/DOWN] again to select the Delay
type (1 ~ 5) or Reverb type (1 ~ 8; see the Data
List book).
5. Press Param [UP/DOWN] again and select the
Delay or Reverb parameter to set (depending on
selected Delay or Reverb type, available
parameters will be different).
6. Press Data [UP/DOWN] again to set the
parameter value as desired.
7. Repeat steps 5 and 6, above, as many times as
necessary to set all parameter values.
79