Yamaha AN1x Owner's Manual page 82

Triggering The Free EG With Patterns
The Free EG can be used in conjunction with the Arpeggiator
or Step Sequencer. When the Trigger is set to "kbd", the Free
EG will be applied to the pattern.
Hold = "on"
EG
Motif
Key On Key Off
Each time you press a key the Free EG will be retriggered.
When the Trigger is set to "all", the Free EG will be
retriggered whenever the Arpeggiator or Step Sequencer is
played.
Loop Type
The Loop Type setting determines the type of loop for
play of the Free EG sequence.
Settings:
off: The Free EG sequence plays once but does not loop. The
parameter settings at the end of the Free EG sequence remain
in effect.
fwd: The Free EG sequence loops from start to end.
half: The Free EG sequence loops from the middle to the
end.
alt (Alternate): The Free EG sequence loops from start to
end, then end to start.
half (Half Alternate): The Free EG sequence loops from
middle to end, then end to middle.
Length
The Length setting determines the time for recording
and play of the Free EG sequence. There are two
Length types, including length determined by number of
measures or by absolute time (seconds).
Settings:
bar (number of measures): 1/2, 1, 3/2, 2, 3, 4, 6, 8
s (seconds): 1.0 ~ 16.0
Key On
Track Confirm and Assignment Procedure
1. Using Track No [UP/DOWN], set the track you
2. Using Param [UP/DOWN], select the parameter
3. Using SceneSw [UP/DOWN], set the Scene
4. If necessary, repeat steps 1 through 3, above,
82
When set to "bar", the Free EG record and play time is determined by the Tempo
setting in the VOICE COMMON menu. This synchronizes the Free EG movement
with the Arpeggiator or Step Sequencer.
Key Track
The Key Track setting determines the length of the Free
EG in relation to notes played on the keyboard, using
C3 as the basic note length. When set to "0", the
length will be the same for all notes across the entire
keyboard. Negative values will cause the Free EG
length to decrease when you play in the lower register,
and positive values will cause the Free EG length to
decrease when you play in the higher register.
Settings: -64 ~ +63
Track
Track settings determine the current Free EG track, the
parameter assigned to each track, and which Scene
the Free EG will play. There are three Track
parameters, including Track No (Number), Param
(Parameter) and SceneSw (Switch).
When you start recording the Free EG, the parameter of the first knob you move,
along with the current Scene setting, will be assigned to the track Parameter (i.e.,
that parameter will be recorded in the track). This is convenient for initiating a
Free EG recording immediately, without making all settings beforehand.
want to record or play.
which you want to record in the track.
(Scene 1, Scene 2, or both Scenes) which you
want the Free EG to affect.
for selecting other tracks and assigning
parameters to them.
You cannot assign the same parameter to more than one track. If you attempt
to do so, the latest recorded track takes priority, while other tracks will
automatically be turned off for the Scene Switch.