Table of Contents
Advertisement
Receiver Setup for a New Wally
The receiver may reboot automatically as part of the update process
(figure 7). If so, select the state of your current location on the
Mobile Antenna Setup screen as in figures 1 and 2. Press "Scan"
to begin the search routine.
The satellite will search for and acquire satellites.
Figure 7
NOTE
If the receiver reboots at this time, restart receiver setup
(see figures 1 & 2).
If the receiver is in Standby mode for more than five minutes, no
TIP
software update is necessary. Turn the receiver back on to resume
normal operation.
DON'T HAVE DISH AT HOME?
NO PROBLEM!
•
Pay for programming one
month at a time
•
No long-term contracts
•
No credit check
5
Updating Receiver Software
(
)
Cont
®
For optimal performance, update receiver software occasionally. To
allow the software to update, leave the satellite on signal, and press
the Power button on the remote or front panel of the receiver; this
will put the receiver in Standby mode (figure 8). Do not unplug the
receiver at this time.
Figure 8
After being in Standby mode for a few minutes, the software will
automatically begin to update (figure 8). Upon completion of
the update, the receiver will reboot. Return to the beginning of
"Receiver Setup for Currently Active or Previously Used Receivers"
to re-acquire satellites and complete setup.
Figure 9
PAY-AS-YOU-GO Features
ALREADY HAVE DISH? GREAT!
•
Add to your current subscription
and enjoy your TV channels every-
where you go - in HD!
1-800-288-8094
Winegard's Receiver Hotline
Advertisement
Table of Contents
