Primera CX1200E Operation Manual page 35

5. Below is an example of edge sensitivity set too low. Notice how the contour line invades the
image on the left side. This is because the image is very light in that area.
6. To retry the edge detection simply click Apply again. Note: The object must stay selected for the
contour toolbar and the apply button to be visible. If it is not visible, repeat steps 1-2.
7. This time, enter a higher value in the threshold window. You may have to repeat this procedure
a few times.
If the cut lines are not smooth,
you may also adjust the Trace
Setup drop down menu.
Typically, Script Text or
CutContour are the best options.
30 Create a Print File