Primera CX1200E Operation Manual page 18

3. The loose stock should fall on the right side of the roll. Turn the tension knob clockwise to
secure the roll to the chuck. Turn the knob as as tight as you can! Feed the stock under the
dancer arm and through the cutter.
Figure 4-3.
Tension Knob
4. Continue feeding the stock into the printer feeder tray. Feed the stock under the green guides
and under the paper feed roller. Stop feeding when the leading edge of the stock has covered
the red stop block printed just outside the feeder door entrance.
Figure 4-4.
Green Guides
Feed Roller
Red Stop Block
Dancer Arm Cutter
Note: To track
supply roll usage,
remember to enter
the length of the
roll using the
instructions in
Section 6.5.
Load Label Stock 13