17. Remove the packing tape from the rewinder dancer arm and move it into the up
(starting) position.
Figure 2-17.
Warning: To prevent serious injury you must bolt the CX1200e to a table or bench. Use the
included lag bolts and predrilled holes in the base.
18. Locate the power converters and the printer power cord. Connect power to the printer and
switch on the power. Connect the power to the back of the rewinder and unwinder. Switch on
the power.
Figure 2-18.
Congratulations! Your CX1200e is setup!
10 Unpack and Assemble
ON
OFF