Section 4. Load Label Stock (Includes Attaching Stock To Rewinder) - Primera CX1200E Operation Manual

Section 4: Load Label Stock
This section details the general process for installing label stock on the unwinder, and attaching the
label stock to the rewinder.
1. Switch on the unwinder, printer and rewinder.
Figure 4-1.
2. Place the label stock roll (max 12" OD) on the unwinder chuck. Push the stock all the way back
until it touches the stop disc.
Figure 4-2.
Note: You must use only 8.5 inch wide label stock in the CX1200e. Failure to use specified label stock
will result in damage to your printer and excessive build up of toner and adhesive inside the printer.
Caution! You can not use die cut label stock in the CX1200e. The extreme heat produced by the fuser
will cause the die cut labels to peel off the label backing and get jammed inside the printer. Also, the
printer is not designed to line up print images with the specific locations of the die cut labels.
12 Load Label Stock