Table of Contents
Advertisement
®
AirSep
Corporation
4.0
Components Description
The drawings in this section illustrate the location of the main components of the
various oxygen generator models. All models include similar components unless
noted otherwise; however, the location and size of these components varies
among the different models. Refer to Appendix of this instruction manual for
general layout drawings and specifications for all the oxygen generator models
referenced in this instruction manual. In addition, the oxygen generator requires use
of an oxygen receiver to provide stable flow and purity for short-term surges of feed
oxygen above the rated capacity of the oxygen generator.
4.1
External Components
Figure 4-1 below illustrates on two models the external components viewed from
the front of the oxygen generator.
AS-B Series Model
AS-A—AS-P Series Instruction Manual
Adsorbers
Control Panel
Enclosure
Figure 4.1: External Components — Front View
AS-E Series Model
4-1
Advertisement
Table of Contents
