Table of Contents
Advertisement
®
AirSep
Corporation
8.0
Troubleshooting
8.1
Technical Support
For assistance in troubleshooting or repairing the unit, or to order replacement
parts, contact the AirSep Commercial Products Service Department by telephone
Monday through Friday between 7:30 a.m. and 4:30 p.m. Eastern Time. In the USA
or Canada, call 1-800-320-0303. Outside the USA or Canada, call (716) 691-0202.
Send fax inquiries anytime to (716) 691-1255. Address written inquiries to:
AirSep Corporation
260 Creekside Drive
Buffalo
NY 14228-2075 USA
Attention: Commercial Products Service Department
E-mail:
cpdservice@airsep.com
Visit
www.airsep.com
Generators.
8.2
Troubleshooting Chart
Use the following chart as a guide to troubleshoot the oxygen generator.
Problem
Oxygen generator does not
cycle. Green light on
ON/OFF switch does not
illuminate.
Oxygen generator operates.
Green light on ON/OFF
switch does not illuminate.
Oxygen generator does not
operate and green light on
ON/OFF switch illuminates.
AUTO/MAN switch set to
MAN and yellow light on
AUTO/MAN switch does not
illuminate.
AS-A—AS-P Series Instruction Manual
to know about our complete range of standard Oxygen
Probable Cause
No electrical power to
control cabinet or blown
fuse on unit.
Blown fuse on unit.
Light bulb on ON/OFF
switch burned out.
Loose or defective wire to
switch.
ON/OFF switch set to
OFF.
Defective ON/OFF switch.
Loose or defective power
wire to circuit board/PLC.
Solution
Make sure unit is plugged
into wall outlet and that
wall outlet receives power.
Replace fuse in unit.
Replace switch.
Repair or replace wire.
Set ON/OFF switch to ON.
Replace switch.
Repair or replace wire.
8-1
Advertisement
Table of Contents
