Table of Contents
Advertisement
®
AirSep
Corporation
Oxygen Outlet
The oxygen outlet provides a connection for the oxygen hose to the oxygen
receiver.
Condensate Drain Outlet
The condensate drain outlet provides a connection for a hose to drain condensate
from the oxygen generator filters (not applied for all the models).
4.2
Control Panel
The control panel on the oxygen generator contains the controls needed to operate
the oxygen generator and monitor its operation. An example of a typical control
panel is shown in Figure 4-2. Not all components are available on every generator.
On the AS-D+ through AS-P models, the gauges are mounted directly on the
manifolds and the hour meter is inside the control panel.
Feed Air
Pressure Gauge
On/Off Switch
Cycle Pressure
Gauge
Hour Meter
On/Off Switch
The l/O power switch starts and stops the operation of the unit. The green indicator
light illuminates to indicate that the oxygen generator is receiving electrical power.
Auto/Manual Switch
The AUTO/MANUAL switch selects the operating mode for the oxygen generator.
In the AUTO position, the oxygen generator cycles on and off to meet the oxygen
demand. In the MANUAL position, the oxygen generator cycles continuously. The
yellow indicator light on the AUTO/MANUAL switch illuminates only when the
oxygen generator produces oxygen.
Manual Drain Button
The oxygen generator uses an automatic valve to periodically drain excess
moisture extracted from the feed air. The manual drain button allows you to
operate the automatic drain valve manually at any time during operation.
AS-A—AS-P Series Instruction Manual
Figure 4.2: Control Panel — AS-B and AS-D Models
Auto/Manual
Switch
Oxygen
Receiver
Pressure
Gauge
Manual Drain
Button
4-3
Advertisement
Table of Contents
