Bending, Tests And Corrections - CYBELEC ModEva Pac User Manual

ModEva Pac User Manual
Complementary explications are found in the 2D Reference Manual.
b , T
endinG eSTS and
This chapter explains how to proceed in order to execute a product. This way of doing is
destined only to demonstrate how to use the numerical control.
The testing and adjusting operations can be carried out in the order decided by the
operator.
S
In the screen above, the correction of
thickness when programming section 2 in
Programming), page
• B S , defines the downward bending speed and the upward moving speed
ending Peed
from BDC to Pinch Point point.
• L S d , defines the portion (expressed in %) of the upward movement
oW Peed iStance
between the TDC and the Pinch Point which will be carried out at low speed; the
continuation of the upward movement is made at high speed.
c
orrecTionS
i :
etting nStructionS
1. Go into semi-automatic mode
2. If necessary, move to the first sequence by means of the
3. Press the start key
4. Carry out the bend with a trial product.
5. Measure the flap and the obtained angle.
6. Touch the
25.
7. If necessary, correct the flap (in this example, a correction of X =
for the current bend.
.
in order to position the axes on the first sequence.
button and select c
orrectionS
-2.00
MM
Bend Numerical Page (Direct
and keys.
in the list.
corresponds to the material
- 0.10 is assumed)
A
pril
2016 27/40
V2.3