Special Functions For A Bend - CYBELEC ModEva Pac User Manual

Special functions
for a bend
Programming 99 in the
possible step bends. The resulting value may be reduced. However, if it is
increased over the maximum calculated value, the resulting radius and angle
will be drastically affected.
A special punch or /and die means there must be an additional working station.
10. Once all the segments and angles adjusted, go to the
A
pril
18/40 2016
V2.3
6. Touch the Section field, enter the value of
initializes a new page for programming section 2.
7. Draw the profile of section 2 (see
the screen where you want to add a segment.
8. Proceed in the same manner as for section 1 to adjust lengths and angles values.
9. If a bend needs special parameters (large radius, special tool), it can all be
programmed on the bend data line of the corresponding sequence.
• Activate a special tool by touching the corresponding field, and select it from a list
(deactivate with the
• Change the value of the radius
make to execute it
page 22).
2
Creating a Part Program, page
button).
(r field) and define how many steps the NC will
i
(cr field).
cr field will automatically calculate the maximum
ModEva Pac User Manual
and leave the field. This automatically
16) by touching
Bend 2D Page (see