TAKATA MINI I-SIZE Instructions Manual page 69

NOTE!
[MINI_I-SIZE_041] If the vehicle's ISOFIX points
DUH GLI¿FXOW WR UHDFK XVH WKH IHHGHU VXSSOLHG WR JXLGH
them out. This makes connecting the system much
easier, and protects the seat cover.
WARNING!
Ensure that both ISOFIX connectors are fully secured
to the vehicle's ISOFIX points. Failure to observe this
notice may seriously risk your child's safety, and the
safety of other passengers. You can check the connectors
are properly secured to the ISOFIX points, by lightly
shaking the TAKATA I-SIZE BASE.
Step 5 – Fit the base against the back of the vehicle seat
[MINI_I-SIZE_042] Press the two buttons to adjust
the length of the ISOFIX connectors, and push the
7$.$7$ ,6,=( %$6( XQWLO LW VLWV ÀXVK DJDLQVW WKH
seat back.
WARNING!
>0,1,B,6,=(B@ :KHQ ¿[LQJ WKH 7$.$7$ ,6,=(
BASE to the vehicle seat, ensure that both ISOFIX
connectors are set correctly and to the same position.
Check this by lightly shaking the TAKATA I-SIZE
%$6( DQG FKHFN WKDW WKH ¿JXUHV RQ WKH WRS RI WKH
connectors match up (or that both are blank). Failure to
observe this notice may seriously risk your child's safety.
Step 6 – Adjust the support leg
[MINI_I-SIZE_044] Set the height of the support
leg, following the instructions in Section 3 – Basic
instructions (Adjusting the support leg), so that its
EDVH OLHV FRPSOHWHO\ DQG ÀXVK DJDLQVW WKH YHKLFOH ÀRRU
and the indicator at the lower end of the support leg
is fully showing a green marking.
WARNING!
[MINI_I-SIZE_045] Ensure that the support leg is
locked into position and that it lies completely and
de
en
fr
it
es
nl
65