TAKATA MINI I-SIZE Instructions Manual page 63

Adjusting the ISOFIX connectors
The two ISOFIX connectors on the TAKATA I-SIZE
BASE must be adjusted, according to the position of the
ISOFIX points in the vehicle. Each of the connectors
can independently be set to one of six different lengths,
ZLWK WKH YDULRXV VHWWLQJV LQGLFDWHG E\ ¿JXUHV  WR 
on the top of them. Setting six is obtained when the
connectors are at full extension, and is indicated by the
DEVHQFH RI DQ\ ¿JXUH
Step 1 – Unlock the ISOFIX length adjuster
[MINI_I-SIZE_031] Press the left-hand button on the
ISOFIX length adjuster as far in as possible and hold
it in position. The adjuster is positioned on the inner
side of the TAKATA I-SIZE BASE.
Step 2 – Adjust the ISOFIX connector
At the same time, pull the left-hand ISOFIX connector,
positioned on the outside of the TAKATA I-SIZE BASE,
into the required position.
Step 3 – Lock the ISOFIX length adjuster
Release the button and connector, and check whether
the latter is locked in place. This is indicated by a click,
and a green marking on the button.
NOTE!
The two ISOFIX connectors must be adjusted
independently. Repeat steps 1 to 3 for the right-hand
connector.
WARNING!
[MINI_I-SIZE_032] When securing the TAKATA
I-SIZE BASE in the vehicle, ensure that both ISOFIX
connectors are set to the same position. To do this, check
WKDW WKH ¿JXUHV RQ WKH WRS RI WKH FRQQHFWRUV PDWFK XS
(or that both are blank). Failure to observe this notice
may seriously risk your child's safety, and the safety of
other passengers, in the event of an accident.
de
en
fr
it
es
nl
59