Recording A Sample - Yamaha 9000 Pro Owner's Manual

Sampling
Sampling
Basic Procedure
1
Press the [SOUND
CREATOR] button.
Refer to "Quick Guide" on page 40 for details.
The operations for each function corresponding to step #4 are covered in the following
explanations.

Recording a Sample

Refer to page 40 for instructions on recording a sample.
The following display will be shown in step #9 on page 40.
You can set the START/END
KEY by pressing the desired
key while holding either of the
LCD buttons.
When FIXED PITCH above is set to OFF, the new recorded sample will be assigned to
C3. Notice that the pitch and speed of the sample "follows" the keyboard: Playing keys
lower than the original results in a lower pitch and slower speed; playing higher keys
results in higher pitch and faster speed.
START KEY
86
Reference
2
Select "SAMPLING."
Set the key range to
which the new sample
will be assigned.
C3
Pitch/speed of
sample goes down.
Original key
3
Select the desired menu.
4
Follow the on-screen instructions.
Set this parameter to ON if
you want the sample to play
back at the same pitch over
the entire key range of the
9000Pro.
Pitch/speed of
sample goes up.
END KEY
Quick Guide
on page 40