MIDI Functions
MIDI Functions
MFC10 Settings
Various functions can be assigned to an optional Yamaha MFC10 MIDI Foot Controller
connected to the 9000Pro.
Connect the MFC10 to the MIDI B terminals and set the MIDI channel for the MFC10
messages by following the on-screen instructions.
The 9000Pro provides two ways to set: Easy Setup and Full Setup.
MFC10
The explanations here apply to step #5 of the Basic Procedure on page 174.
I Easy Setup
Follow the on-screen instructions to call up the template display as shown below.
Select a template.
178
Reference
MIDI OUT
MIDI IN
MIDI cable
MIDI IN
MIDI OUT
PAGE CONTROL
BACK
NEXT
Press the [NEXT] button to enable
the selected Easy Setup template.
Disconnect the MIDI cable from the
MIDI OUT B terminal and connect it
to the MFC10 Foot Controller.
9000Pro
• When the MIDI B terminals are
connected to the MFC10, the
functions of the MIDI B port are
limited. For details, refer to the
MIDI Data Format (page 228).
• When setting up the MFC10
from the 9000Pro, a MIDI cable
must be connected from the
MIDI OUT of the 9000Pro to
the MIDI IN of the MFC10.
However, you should discon-
nect this cable when using the
MFC10, since extraneous MIDI
messages may be transmitted
from the 9000Pro.
• To exit from the MFC10 play
mode, select the MIDI Tem-
plate display (page 174) and
press the [CANCEL] LCD but-
ton.
• The MFC10 play mode on/off
status is retained in Flash
ROM and is maintained even
when the power is turned off.