Yamaha 9000 Pro Owner's Manual page 89

G Loop Point
This display determines how your sampled waves play back.
Your sampled waves can be played back in three different ways as follows:
WAVE
START
WAVE
START
WAVE
START
See above.
Press this to automatically
remove all data prior to the
specified Start point and
after the End or Loop End
point of your sample.
See the illustration below.
Sample
A B C
Loop Start
Start point
point
END
END
LOOP LOOP
START END
When the ONE SHOT or REVERSE is
selected, select either the Start or End
address of the wave.
When the LOOP is selected, select the Start,
Loop Start or Loop End address of the wave.
When this is turned ON, the LOOP ADDRESS
LCD buttons will automatically only select
points in the wave corresponding to, or adja-
cent to, zero level points.
Extract
D E
Loop End
point
Example
A B C D
Start point Loop Start
point
B, C, D, C, D, C, D ....
Press this to actually edit
the selected wave.
The LEVEL indicators the right of each address
show the signal level at the current address —
the longer the bar, the higher the signal level.
This makes it easier to locate zero-level points
for noise-free trimming and looping.
Sample
B C
Loop Start
Start point
point
Sampling
Sampling
E
Loop End
point
D
Loop End
point
89
Reference