Chapter 5: Connect Media Gateways
Note:
Complete these steps only if you are connecting more than one G700 Media
Note:
Gateway in a stack configuration.
Single-stack redundancy
1. Using the gray X330SC short cables,
connect the media gateways from the
bottom up:
Connect the light gray connector to the
●
port labeled "Cable to upper unit."
Connect the dark gray connector to the
●
port labeled "Cable to lower unit."
Repeat both steps until all units in the
●
stack are connected (maximum of 10
units).
2. For single-stack redundancy, connect the
bottom unit and the top unit using the
black X330RC redundancy cable:
Connect the light gray connector to the
●
port labeled "Cable to upper unit: on
the top unit of the stack.
Connect the dark gray connector to the
●
port labeled "Cable to lower unit" on
the bottom unit of the stack.
Issue 7 February 2006
19