VERITAS 5150 Hardware Service Procedure page 3

Replacing a faulty solid state disk carrier

Hide thumbs Also See for 5150:

You can also find the serial number in the pull out tab on the front of the appliance.

Locating and removing the faulty SSD carrier

To locate and then remove the faulty SSD carrier

Put on a grounded ESD-compliant wrist strap or take other ESD-preventive measures.

Note: The static discharged by human bodies can damage static-sensitive components on the

boards. When installing and maintaining the equipment, you must observe appropriate electrostatic

safety precautions to prevent personnel injuries or device damage.

If applicable, remove the front bezel. To remove the bezel, unlock the bezel with the key. Gently

grasp and pull the left side of the bezel towards you, and slide it out from the right rack handle.

In the front panel, locate the drive to be replaced using the slot number.

To remove the SSD carrier, insert a flat head screw driver into the middle slot on the carrier and

carefully leverage the screw driver to pop the carrier out far enough to grab the end of the carrier

and pull it out.

QRB # 290: Replacing a faulty SSD