Faults - Probable Causes - Solutions - Riello RS 1000/EV BLU Installation, Use And Maintenance Instructions

8

Faults - Probable causes - Solutions

If faults arise in ignition or operations, the burner performs a
"safety stop", which is signalled by the red burner lockout LED.
The display visualises alternately the lockout code and the rela-
tive diagnostic. To reset the start up conditions, see the "Reset
procedure" in the control box's manual.
When the burner starts again, the red LED goes out and the con-
trol box is reset.
In the event the burner stops, in order to prevent
any damage to the installation, do not unblock the
burner more than twice in a row. If the burner
WARNING locks out for a third time, contact the customer
service.
In the event there are further lockouts or faults
with the burner, the maintenance interventions
must only be carried out by qualified, authorised
DANGER personnel, in accordance with the contents of this
manual and in compliance with the standards and
regulations of current laws.
Faults - Probable causes - Solutions
33 GB
20123781