Table of Contents
Advertisement
SAFETY AND HOMOLOGATION STATEMENTS
D
C
ECLARATION OF
ONFORMITY
See the associated Declaration of Conformity documents, located within the Approvals folder.
S
R
TATUTORY
ESTRICTIONS
All ISDN and WAN cables used with this product must not be longer than 3m. Refer to Cables, page
23 for details.
The 2A 16V Lump-in-Line PSU supplied with the ArgentBranch must only be connected to
50Hz/60Hz AC power sources in the range 100 – 240V.
A
USTRALIAN REQUIREMENTS
Ensure that User Entries only exist for Terminals that are physically connected to the Phone
Expansion module. Any unused extension ports must not have a User Entry configured, as this will
prevent calls being forwarded to unconnected extensions.
BRI Interface
During the configuration, ensure "000" emergency number is not barred, by performing the
following:
Short Code: "000"
Telephone No.: "000;"
Function: "DialEmergency"
This equipment will be inoperable during mains power failure.
Connections to TS013, the following Bearer Capabilities shall not be used:
7kHz Audio
Video
Restricted Digital Information
If unknown type of number is used in calling party number, the network will use the default CLI.
The system must be configured for Point - Multi point connection to comply with Austel
requirements for connecting to TS013 circuits.
PRI Interface
During the configuration, ensure "000" emergency number is not barred, by performing the
following:
Short Code: "000"
Telephone No.: "000;"
Function: "DialEmergency"
This equipment will be inoperable during mains power failure.
Revision 2
Section 1: Introduction to ArgentBranch
9
Advertisement
Table of Contents
