Ebotics Code & Drive User Manual page 33

STEP 10
PIECES REQUIRED
Holder for the ultrasonic sensor
and its nuts and screws
STEP 11
PIECES REQUIRED
X8 X8
Nylon spacers
M3
M3/12
11.1 Place a LED on each side. Place the buzzer and the button at the rear side of piece C.
11.2 Use the two parallel slots to screw the sensors to piece C. You can modify their position
through the slot guide. Use a nylon spacer between the sensors and the piece C to screw
them. Use a nut to tighten them.
X1 X1
Ultrasonic sensor
X1
X8
NUTS
M3
Buzzer
10.1 Place the ultrasonic sensor
holder over the two front holes
of piece C.
10.2 Screw the holder to piece C and
use its nuts to tighten it.
10.3 Insert the ultrasonic sensor
through the holder holes. The
sensor pins must be facing up.
10.4 Connect the black-red-blue-
orange cable to the ultrasonic
sensor.
X1 X2
Button LEDS
CODE & DRIVE MANUAL
Black-red-blue-orange cable
X4
Black – Red – Yellow cables
33