Ebotics Code & Drive User Manual page 28

Picture 4.1
4.4. Place the battery holder under piece C.
4.5. Put 2 screws through the holes of the battery holder, they should protrude piece C.
4.6. Put 2 nylon spacers, one for each screw, and tighten the hexagonal spacers until the
structure is fastened.
4.7. Pass the cable of the battery holder through the rear-left hole from bottom to top.
4.1. Put a nylon spacer on
each of the 4 front holes
of piece C.
4.2 Put the 2 analog light
sensors over the nylon
spacers. The sensor,
spacer and piece C holes
must be aligned.
4.3. Insert 2 screws, one for
each sensor, through the
side holes of the sensor.
Verify its position with
picture 4.1. Use a nut to
tighten each screw.
CODE & DRIVE MANUAL
28