Ebotics Code & Drive User Manual page 30

6.1. Place the piece E in a position that its holes are aligned with the Build&Code 4in1 board
holes. Put 4 nylon spacers on the 4 middle holes of piece E.
6.2. Without moving the nylon spacers, place the Build&Code 4in1 board on it and screw it
through the spacers and piece E. Use a nut to tighten each screw.
STEP 7
PIECES REQUIRED
X2
X4
Nylon spacers
M3
M3/12
Mounted
piece A
** Before doing this step remember
to remove the screws and nuts from
the light sensors if you used them
at step 4.
CODE & DRIVE MANUAL
Mounted
piece C
30