Ebotics Code & Drive User Manual page 26

STEP 2
PIECES REQUIRED
X2 X2
X4
X4
nuts
M3
Black – Red – Yellow cables
X4
M3/30
DC Motors
Pieces B
Picture 2
2.1. As shown in picture 2, place 1 piece B from the bottom to the top through the middle right
hole of piece A.
2.2. Put a DC motor on the external side of piece B. The cable should stay in the inner side of
the assembly.
2.3. Put 1 piece B on the external side of the DC motor. Place 2 screws that will go through piece
B, DC motor and the inner piece B. Use the nuts to tighten them. Screws and nuts must remain
a bit loose.
Note: If the screws don't fit easily into the holes, move the B pieces and the DC motors so that
they fit correctly.
2.4. Repeat the process with the other DC motor. Be sure to insert the screws from the external
side of the assembly; and that the DC motors cables are set on the motor's inner side.
2.5. Connect the black – red – yellow cables into the sensors. The connector tab must coincide
with the sensor holder and it must remain locked.
26
CODE & DRIVE MANUAL