Ebotics Code & Drive User Manual page 32

STEP 9
PIECES REQUIRED
X2 X2
Nylon
spacers M3
M3/12
Mounted piece E
Picture 9
9.1. Place piece E in the position shown in picture
9. Set piece E over the metallic spacers placed
at the top of piece C. Align the holes of piece E
with the metallic spacer, insert 2 screws through
piece E, put a nylon spacer on each screw which
should be between piece E and the hexagonal
metal spacer. Then you can screw them.
** If the screws don't go through easily, loose a
little bit the 4 screws of the Build&Code 4in1 board.
Once you have fixed piece E on its place, tighten the
screws again.
CODE & DRIVE MANUAL
32