Ebotics Code & Drive User Manual page 29

STEP 5
PIECES REQUIRED
X1
Piece D
** Please note that piece D is not symmetric. Pay attention to the pictures to assemble it correctly.
5.1. Place the ball wheel on the center of piece D. Put the screws through the holes and let them
protrude the piece D and tighten them with 2 nuts, one for each screw.
5.2. At the sides of the piece C put 2 screws M3*12 from top to bottom, each screw must have a
nylon spacer. Tighten the metal spacers to the screws after they are completely protruded.
STEP 6
PIECES REQUIRED
X1
Piece E
X1
Ball wheel
Picture 5
X4
Nylon
spacers M3
X4 X4
NUTS
M3
M3/12
X4 X2
NUTS
M3
spacers M3
Hexagonal metal
M3/12
female - female
spacer M3*25
X1
Build&Code 4in1
CODE & DRIVE MANUAL
X2
X2
Nylon
Picture 5.1
29