Table of Contents
Advertisement
Keystone OM3 - EPI-2 LOcaL IntErfacE MOduLE
InstallatIon and MaIntenance InstructIons
2. InStaLLatIOn
to assemble the OM3 Local Interface module
onto the EPI-2 actuator, proceed as follows:
• Ensure that all the parts received with the
OM3 are available (see figure 1):
pos.
description
1
Local Interface module
2
Screws for connecting connector
• Gather the right tools for the assembly
(a 5 mm allen key and a screwdriver,
figure 2).
• With the Allen key loosen the 4 cover screws
and remove the terminal board enclosure
cover (see figures 3/3a).
You will see the terminal board inside the
actuator. remove the ground cable from the
cover in the enclosure. the position of the
connections is shown on the yellow label that
you will find inside the cover just removed
(see figures 4/5).
WarnIng
Pay attention not to damage the joint surfaces
of the cove/enclosurer.
1
Q.ty
1
4
OM3 kit for EPI-2 actuator
fIgure 1 -
tools for installing OM3 kit
fIgure 2 -
removing terminal board enclosure cover
fIgures 3/3a -
Electrical connections
fIgures 4/5 -
2
2
Advertisement
Table of Contents
