Energy Saver - Xerox PHASER Phaser 7700 User Manual

Energy saver

After a predefined period of time since its last activity, the Phaser 7700
printer enters E
NERGY
systems are shut down. When a print job is sent to the printer, it will
wake up the printer. You can also wake the printer by pressing the OK
key on the front panel.
You may find that the printer is going into E
too often and you do not want to wait for your print jobs while the
printer is waking up. If you want to extend the length of time before
the printer goes into E
With Menus highlighted, press the OK key.
1.
2. Scroll to Printer Setup Menu by pressing the Up or Down Arrow
key.
3. Press the OK key.
4. Scroll to Set Energy Star Timeout by pressing the Up or Down
Arrow key.
5. Press the OK key.
6. Increase the amount of time the printer can be idle before going
into E
NERGY
7. Press the OK key.
User Guide
®
S standby mode. In this mode, the printer
TAR
S
NERGY TAR
S mode by pressing the Up Arrow key.
TAR
S
NERGY
mode, use the following procedure:
standby mode
TAR
15