Using The Stapler - Xerox PHASER Phaser 7700 User Manual

Using the Stapler

The optional finisher can staple sets of up to 50 sheets of 90 g/m
(20 lb. bond) paper or 35 sheets of 105 g/m
the set of copies is stapled, it is delivered to the finisher output tray.
The stapler holds 5000 staples.
Note
You cannot staple from the Multi-Purpose Tray (MPT).
Notes about stapling:
If output sheets are sent to the stapler unit but the sheet count
I
exceeds 50, the sheets are sent to the finisher tray without being
stapled. Further sheets then bypass the stapler unit, going directly
into the finisher tray.
If output sheets are sent to the stapler unit and then the paper type
I
changes during the job to an unsupported type, stapling is turned
off and any sheets in the stapler unit are sent to the finisher
output tray. Unsupported paper types then bypass the stapler
unit, going directly into the finisher tray.
If stapling is on and you are printing multiple copies, check the
I
Collate box, otherwise all the copies of each page are stapled
instead of each set of copies.
When the stapler is empty, a message displays on the front panel
I
but printing continues with pages sent to the finisher tray without
being stapled.
If you select the top output tray and stapling, the output will be
I
stapled and sent to the finisher output tray not the top output tray.
User Guide
2
(28 lb. bond) paper. Once
2
49