Care And Storage - SATA SATAjet 1000 A RP Operating Instructions Manual

Operating Instructions for SATA Automatic Guns
US
■ Install gasket [16-6], washer [16-5]
and pressure spring [16-4] in control
piston.
■ Slide on collar [16-3]. Pay attention to
alignment of groove [16-10].
■ Install washer [16-2].
■ Tighten hollow screw [16-1].
■ Install O-ring [16-8].
■ Tighten Allen screw [16-9].
■ Install control piston [15-6].
■ Install paint needle [15-5].
■ Install both springs [15-3], [15-4].
■ Screw on end cap [15-2].
■ Screw on regulating cap [15-1].
■ Adjust required material flow rate (see
Chap. 9.2).
10.6. Replace control piston
seal retainer
Remove control piston seal retainer
■ Unscrew regulating cap [17-1].
■ Unscrew end cap [17-2].
■ Remove both springs [17-3], [17-4].
■ Remove paint needle [17-5].
■ Pull control piston [17-6] out with
duck-billed pliers.
■ Unscrew seal retainer (19 mm) [17-
7].
■ Check parts for damage and contami-
nation, clean or replace as required.
Install new control piston seal retainer
■ Screw in seal retainer [17-7].
■ Install control piston [17-6].
■ Install paint needle [17-5].
■ Install both springs [17-3], [17-4].
■ Screw on end cap [17-2].
■ Screw on regulating cap [17-1].
■ Adjust required material flow rate (see
Chap. 9.2).
428

11. Care and Storage

Careful handling as well as continu-
ous service and care of the product
are required to guarantee proper
function of the automatic gun.
Clean automatic guns each time
after use and check for proper func-
tion and leakage. After cleaning,
dry entire automatic gun with clean
compressed air.
Danger!
If the compressed air circuit
and material supply are not dis-
connected before performing
cleaning work, components can
detach and/or material escape
unexpectedly.
→ Always disconnect automatic
gun from compressed air cir-
cuit and material supply before
performing any type of cleaning
work.