Offsetting Output - Xerox PHASER Phaser 4400 Paper Manual

Offsetting output

When you send output to the 500-sheet stacker, you can also select offsetting. Offsetting separates print
jobs or collated sets of a single job by approximately 25 mm (1 in.) in the output tray.
Note
If you send output to the Standard Output Tray, the printer does not offset the output.
The 500-sheet Stacker offsets output, but you must have a hard drive to have the printer
offset collated sets.
You can switch job offsetting on or off on the front panel:
1.
With highlighted, press the OK key.
Menus
2. Scroll to
Printer Setup Menu
3. Scroll to
Job Defaults Menu
4. Scroll to
Job Offset
5. Select either or
On Off
Note
If you change job offsetting in your printer driver, this overrides the front panel setting for
your print jobs.
Phaser™ 4400 Laser Printer
using the Up Arrow or Down Arrow key and press OK.
and press the OK key.
.
by pressing the OK key.
Output Trays
34