Table of Contents
Advertisement
g.
Press the Down Arrow or Up Arrow key to scroll to the value for X, and then press the
OK key. (The X value is the measurement from the left to the right of the paper in the tray.)
h.
Scroll to
Set Custom Y
i.
Press the Down Arrow or Up Arrow key to scroll to the value for Y, and then press the OK
key. (The Y value is the measurement from the front to the back of the paper in the tray.)
Turning off custom sizes
When you use standard size paper in the tray and adjust the guides for that paper, you don't need to
specify the paper size in the front panel. The trays contain size sensors that automatically inform the
printer about the paper size. However, when you insert custom size paper in the tray and change
to
, the size sensors are turned off and you must enter the X and Y values as
Custom Size
On
described in Step 4 on the previous page. If you later insert standard size paper in the tray, you must turn
on the tray sensors again by changing
1.
On the front panel with
2.
Scroll to
Printer Setup Menu
3.
Scroll to
Tray Setup Menu
4.
Scroll to
Tray # Setup Menu
5.
Scroll to
Custom Size
reactivates the tray sensors for that tray.
Phaser™ 4400 Laser Printer
and press the OK key.
Custom Size
highlighted, press the OK key.
Menus
by pressing the Down Arrow key and press the OK key.
and press the OK key.
(where # is the number of the tray) and press the OK key.
and press the OK key to change
to
:
Off
Custom Size
Trays
to
. This
Off
14
Advertisement
Table of Contents
