Wiring Example For Safety Sensor - Panasonic SF4С Series Instruction Manual

Functions

3.4.3 Wiring Example for Safety Sensor

If you want to wire a safety sensor you have to consider if you use the PNP and NPN type of
SF4C.
Wiring for PNP output
When using this device with PNP output, connect a PNP output type safety sensor. Connect the
emitter of the SF4C and the receiver of the safety sensor as follows.
In case of using lead wires other than those described below, perform wiring depending on your
application. For details on wiring, see "Wiring" on page 34.
Emitter of SF4C
Safety input wire 1 (gray)
Safety input wire 2 (gray/black)
+V wire (brown)
0V wire (blue)
66
SEN TRONIC
AG
Produkte, Support und Service
Receiver of the safety sensor
Control output 1 (OSSD 1) wire (black) or control output 2 (OSSD 2) wire
Control output 2 (OSSD 2) wire (white) or control output 1 (OSSD 1) wire
Rugghölzli 2
CH - 5453 Busslingen
SF4C Safety light curtain
(white)
(black)
+V wire (brown)
0V wire (blue)
Tel. +41 (0)56 222 38 18
Fax +41 (0)56 222 10 12
mailbox@sentronic.com
www.sentronic.com