SF4C Safety light curtain
2.5 Mounting
The standard mounting bracket MS-SFC-1 is included with the device. Other mounting brackets
appropriate for your installation environment, has to be purchased separately. Please, also
purchase the hexagon socket head bolts separately. They are not part of the product.
•
Standard mounting bracket (MS-SFC-1)
•
NA2-N compatible mounting bracket (MS-SFC-2)
•
Multifunctional Mounting Bracket MS-SFC-3 (see page 119)
2.5.1 Mounting with Standard Mounting Bracket
Before you start mounting the device, read the following important notes carefully.
NOTE
•
Do not bend the cable of this device. Applying improper loads to the cable
could cause the wire to break.
•
The minimum bending radius of the cable is 6mm. Mount the sensor
accordingly.
•
Mount the emitter and the receiver at the same level and parallel to each
other. The effective aperture angle of this device is ±2.5°or less for a sensing
distance exceeding 3m.
•
Unless otherwise specified, the mounting procedure is common for both
emitters and receivers. To prepare the mounting holes, refer to the
dimension diagrams.
Unless otherwise specified, the following mounting procedure is common for both emitters and
receivers. The direction of the standard mounting bracket MS-SFC-1 (accessory) which is
attached to this device can be changed depending on the mounting position of the device.
SEN TRONIC
AG
Produkte, Support und Service
Rugghölzli 2
Tel. +41 (0)56 222 38 18
CH - 5453 Busslingen
Fax +41 (0)56 222 10 12
2.5 Mounting
25
mailbox@sentronic.com
www.sentronic.com